OPERATING MODES

The UV Clean Mat Platform has 2 operating modes:

​

1 - HIGH FLOW: After the 8-second cycle, as soon as the user descends from the platform, the UVC lamp will remain on with 10% of its power waiting for the next user.

When the next user goes up on the platform, the lamp will light at 100% of the power for the 8-second cycle and, at the end, it will return to 10%.

After 5 minutes of non-use, the lamp is turned off and will not be turned on again until the next user goes up.

This method is indicated for customers with a high flow of people using the platform, as this way, the lamp wear is less and its useful life is increased.

​

2 - LOW FLOW: After each 8-second cycle, the UVC lamp is completely switched off and only on again by the next user.

This method is suitable for customers with a low flow of people.

​

LOW FLOW is advised when less than 1 person every 5 minutes uses the platform. When there is a peak or a large number of people at a certain time of the day, we recommend using the HIGH FLOW mode.

​

By default, the device is shipped in HIGH FLOW mode, to switch between modes:

​

a) DISCONNECT THE APPLIANCE FROM THE OUTLET

b) RISE ON THE PLATFORM AND POSITION THE LEFT FOOT IN THE STERILIZATION AREA

c) WITH THE LEFT FOOT PRESSED, PLACE THE APPLIANCE IN THE OUTLET

d) STILL WITH THE FOOT PRESSED, WAIT THE 10 BIPS AND THE GREEN LED FLASHES

e) READY, MODE HAS CHANGED

​

To return to the previous mode, repeat all the steps above.

​